Code No. P0223: Throttle Position Sensor (sub) Circuit High Input


OPERATION



  • A power voltage of 5 V is applied to the electronic-controlled throttle valve connector terminal from the engine-ECU connector terminal TPS5.
  • The power voltage is earthed to the engine-ECU connector terminal TPSE from the electronic-controlled throttle valve connector terminal.
  • The sensor signal is inputted to the engine-ECU connector terminal TPSS from the electronic-controlled throttle valve output terminal.

FUNCTION



  • The throttle position sensor converts the throttle valve position into voltage and inputs it into the engine-ECU.
  • The engine-ECU controls the throttle valve opening angle.

TROUBLE JUDGMENT


Check Condition
  • Ignition switch is "ON" position.
Judgement Criterion
  • Throttle position sensor (sub) output voltage is more than 4.8 V.

FAIL-SAFE AND BACKUP FUNCTION



  • Throttle opening degree is restricted.
  • Throttle opening degree position is in default position if throttle position sensor (main) fails.

PROBABLE CAUSES



  • Failed throttle position sensor (sub)
  • Open circuit and harness damage in throttle position sensor (sub) circuit or loose connector contact
  • Failed engine-ECU

DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III data list

  • Data list reference table (Refer to ).

  1. Item 15: Throttle position sensor (sub)

Q. Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Go to Step 2.

STEP 2. Perform resistance measurement at electronic-controlled throttle valve connector.

  • Disconnect connector, and measure at harness side.
  • Resistance between terminal engine-ECU TPSE line and body earth.
OK: Continuity (2 Ω or less)

Q. Is the check result normal?
Go to Step 5.
Go to Step 3.

STEP 3. Check harness between electronic-controlled throttle valve connector terminal and engine-ECU connector terminal TPSE.

  • Check earthing line for open circuit and damage.

Q. Is the check result normal?
Go to Step 4.
Repair or replace the connector, or repair the damaged harness wire.

STEP 4. M.U.T.-III data list

  • Data list reference table (Refer to ).

  1. Item 15: Throttle position sensor (sub)

Q. Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
Replace the engine-ECU.

STEP 5. Replace the electronic-controlled throttle valve

  • After replacing the electronic-controlled throttle valve, reconfirm whether the diagnosis code is set.

Q. Is the diagnosis code set?
Replace the engine-ECU.
Check end.